GM 9.5" RING GEAR, 14 BOLT DIFFERENTIAL COVER FOR H2 AND GM

Typical applications include the following. Be aware that for each model and year there may be more than one rear axle possible. See also GM 10 bolt 8.5 and 14 bolt 10.5.

  ½ Ton Trucks, 1988 to Current:

• C10 & K10
• C1500 & K1500
• Silverado 1500 & Sierra 1500
• Silverado 1500HD & Sierra 1500HD

¾ Ton Trucks, 1979 to Current:

• C20 & K20
• C2500 & K2500
• Silverado 2500 & Sierra 2500

¾ Ton Vans, 1981 to Current:

• Vandura
• Express
• Savana
• G2500

1 Ton Vans, 1982 to 1995:

• Vandura
• Savana
• G3500

Suburban ¾ Ton: 1988-Current

Avalanche

Trailblazer SS

Hummer H2

Chevrolet SSR (6 speed)

This diff cover features an oil fill/level check hole and drain hole and an undrilled boss for a temperature sensor. Please call to order if you would like the boss drilled and tapped.

For GM applications, see also P/N 9504 (click here). P/N 9504 has more capacity but does not have the oil fill/level check hole. P/N 9504 will not fit on Hummer H2.

Note: GM has used four different bolts on these differentials so to complete your order, we need to know which bolts you have. These differentials have used both metric and standard cover bolts. The bolt length has not been consistent either. When ordering one of these covers, you will need to pull one of your stock bolts out (a top bolt is best) and measure the length and determine whether it is metric or standard.

• Bolt length is measured from the underside of the head (where a washer would sit) to the tip.
• Metric bolts will have 20 threads per inch, standard ones will have 18. Also, a bolt head with lines or letters on it is typically standard. A bolt with numbers such as 5.8, 9.8, 10.9, or 12.9 is likely to be metric.

Please note the length of your stock bolts, and whether they are standard or metric in the vehicle information section when placing your order so we can provide the correct bolts.

Some older versions of this cover with an extra bolt hole are available in our specials section.

Volume: 0.5 qt. over stock

Click here for dimensions.

Price for as-cast finish: $180.00

Price for black powder coating: $220.00

Price for polished part: $290.00

For a larger picture, please click one of the above images. A separate window will open showing a bigger picture. (The larger pictures take a minute to display.)

PML Differential Cover Features:

• Increased oil capacity for cooler temperatures
• Sand-cast aluminum with raised fins
• 3/16-inch thick wall construction to add strength to differential housing
• 3/8-inch thick gasket flange will not bend when bolts are tightened
• Machined gasket surface for a secure seal using RTV or factory reuseable gasket
• Oil changes without removing the cover
• All hardware provided, including magnetic drain plug