FORD STERLING 10.25" & 10.5" RING GEAR, 12 BOLT DIFFERENTIAL COVERS
P/N 9513
P/N 10816
This differential cover fits the Sterling rear end found on 1993 and newer:
- F250 and F350 single rear wheel
- Excursion
If you have an F350 dually, see the Dana 80 differential cover.
The cover has holes for drain and fill. A boss on side optionally can be machined for a temperature sensor for an additional cost. Call to order machining and let us know your sensor thread size. The level check hole for this differential is provided by Ford and is located on the driveshaft side of the differential housing.
Volume: 0.8 qt. over stock
Click here to see a picture of this differential cover (fin pattern P/N 9513) on the Kelderman Screamin' Diesel project truck.
Click here for an article by The Diesel Garage showing the installation of this differential cover (fin pattern P/N 9513) and our Dana 50/60 Front cover (P/N 9866).
Click here for dimensions.
Price for as-cast finish: $180.00 
Price for black powder coating: $220.00
Price for polished part: $290.00
Price for as-cast finish: $180.00
Price for black powder coating: $220.00
Price for polished part: $290.00
For a larger picture, please click one of the above images. A separate window will open showing a bigger picture. (The larger pictures take a minute to display.)
PML Differential Cover Features:
- Increased oil capacity for cooler temperatures
- Sand-cast aluminum with raised fins
- 3/16-inch thick wall construction to add strength to differential housing
- 3/8-inch thick gasket flange will not bend when bolts are tightened
- Machined gasket surface for a secure seal using RTV or factory reuseable gasket
- Oil changes without removing the cover
- All hardware provided, including magnetic drain plug
