FORD 8.8" RING GEAR, 10 BOLT DIFFERENTIAL COVER
P/N 9519
Note to Expedition owners: this cover may be too deep to clear the track bar that runs behind the differential cover. Using the dimensions available below, please check your vehicle for clearance before purchasing this cover.
Has drain hole. To fill, use the factory location which is on the driveshaft side of the third member.
Volume: 0.6 qt. over stock
Click here for dimensions.
Price for as-cast finish: $155.00 
Price for black powder coating: $195.00
Price for polished part: $265.00
Looking for a lower cost alternative? PML has a small number of these 8.8 covers with a machining defect available for a special price. Click here for more information.
For a larger picture, please click one of the above images. A separate window will open showing a bigger picture. (The larger pictures take a minute to display.)
PML Differential Cover Features:
- Increased oil capacity for cooler temperatures
- Sand-cast aluminum with raised fins
- 3/16-inch thick wall construction to add strength to differential housing
- 3/8-inch thick gasket flange will not bend when bolts are tightened
- Machined gasket surface for a secure seal using RTV or factory reuseable gasket
- Oil changes without removing the cover
- All hardware provided, including magnetic drain plug
