Nissan RE5-R05A Deep Transmission Pan
P/N 11037
Price for as-cast finish: $205.00 
Price for black powder coating: $245.00
Price for polished part: $315.00
This transmission oil pan for the Nissan RE5-R05A transmission fits Titan and Armada. It may also fit latest generation Frontier V6, Xterra V6, Pathfinder V6, 350Z and some rear wheel drive Infiniti. This pan features a magnetic drain plug, a temperature sensor boss, extra capacity, and raised fins to help get rid of heat.
PML designed this tranny pan with internal baffles. The baffles help direct oil flow to keep oil at the filter inlet, prevent sloshing, and aid heat transfer from oil to pan. See image below of the baffles.
7/16/2008 Status: This is a new transmission pan. Our first batch of castings has sold out. The next batch will ship at the end of August. We have a backlog of 20 pans to ship. Pre-orders are welcome. The prices above are still the pre-order prices.
Volume: 3.5 qts. over stock
Dimensions are in this pdf file. This pan is 2 ¼ inches deeper on the outside and 1 ½ inches deeper on the inside than a stock Titan pan at its deepest point.
Other picture shows the inside of the pans. Note the baffles in the PML pan.
Click on images to view larger pictures in a new window.
The below image are from the first install of this tranny pan on Darryl's 2005 Titan SE 4WD crew cab. Our thanks to Darryl for working with us.
Before picture:Stock pan on Darryl's truck
After picture:PML extra-capacity pan installed
Darryl's truck - looking good!For a larger picture, please click one of the above images. A separate window will open showing a bigger picture. (The larger pictures take a minute to display.)
PML Transmission Pan Features:
- Increased oil capacity for cooler temperatures
- Sand-cast aluminum with raised fins
- 3/16-inch thick wall construction to add strength to the transmission case
- 3/8-inch thick gasket flange will not bend when bolts are tightened
- Machined gasket surface for a secure seal
- Boss cast into pan can be machined for a temperature sensor
- Magnetic drain plug for easier, less messy maintenance
- Mounting hardware provided
Gasket and filter not included (use stock parts).
If you would like PML to machine your pan for a temperature sensor, there is an additional charge of $35. Please place your order over the phone if you would like machining.
