FORD E4OD, 4R100 2WD & 4WD DEEP TRANSMISSION PAN
P/N 9323
Price for as-cast finish: $220.00 
Price for black powder coating: $260.00
This PML tranny pan for Ford vehicles fits 1989-2004 Ford 2WD and 4WD with the E4OD or 4R100 transmission. Typical applications are:
- F250, F350, F450, F550 and F150 Lightning trucks
- Some full size Broncos
- Excursion
- E250 (5.4 V8), E350, E450 vans and motorhomes
- Lincoln Navigator
If you have a 460 V8 and a "Banks Power Pack" kit or an Excursion with a V10, please check carefully for clearance between the exhaust and the transmission pan.
Excursion owners: This pan will clear the frame cross member. If you have a 4WD, you may need to loosen the rear trans mount bolts and jack up the transfer case slightly to ease access to the bolts along the back of the pan.
If you have a 6.0 diesel, or a 2005 or newer vehicle you'll need a TorqShift pan instead of this one.
To see an image comparing PML and stock pans click here.
Click on image for a larger view in a separate window.This pan has two possible locations for a temperature sensor. One is the boss to the left of the drain hole (as shown in this image) and the other is opposite the drain hole on the passenger's side. These bosses do not come machined. Image at right shows hole drilled on driver's side boss .
Volume: 3.0 qts. over stock for 4WD, 3.5 qts. over stock for 2WD
Click here for dimensions.
For a larger picture, please click one of the above images. A separate window will open showing a bigger picture. (The larger pictures take a minute to display.)
PML Transmission Pan Features:
- Increased oil capacity for cooler temperatures
- Sand-cast aluminum with raised fins
- 3/16-inch thick wall construction to add strength to the transmission case
- 3/8-inch thick gasket flange will not bend when bolts are tightened
- Machined gasket surface for a secure seal
- Boss cast into pan can be machined for a temperature sensor
- Magnetic drain plug for easier, less messy maintenance
- Mounting hardware provided
Gasket and filter not included (use stock parts).
If you would like PML to machine your pan for a temperature sensor, there is an additional charge of $35. Please place your order over the phone if you would like machining.
