![]() |
|
Nissan RE5R05A Deep
|
P/N 11037 |
|
![]() |
![]() |
|
| As-cast finish
$225.00
|
Black powder coating
$275.00
|
Polished finish
$340.00
|
|
Volume: 3.5 qts. over stock Dimensions: are in this pdf file. This pan is 2 ¼ inches deeper on the outside and 1 ½ inches deeper on the inside than a stock Titan pan at its deepest point. We have a low profile version of this pan in development. Number of Bolts: 22 This transmission oil pan for the Nissan RE5R05A transmission fits Titan and Armada. It may also fit latest generation Frontier V6, Xterra V6, Pathfinder V6, 350Z and some rear wheel drive Infiniti. This pan features a magnetic drain plug, a temperature sensor boss, extra capacity, and raised fins to help get rid of heat. PML designed this tranny pan with internal baffles. The baffles help direct oil flow to keep oil at the filter inlet, prevent sloshing, and aid heat transfer from oil to pan. The filter on the RE5R05A is a screen, and it bolts on to the valve body of the transmission so no filter supports or extentions are needed. This transmission pan works with stock gaskets. These are usually about $20 to $25 from your local Nissan dealer. The Nissan part number 3139790X0A (2007 and newer) or 3139790X00 (2003 to 2007). |
||
![]() |
![]() |
PML's pan compared to a stock Titan tranny pan. The PML pan has not yet been machined.
Note the baffles on the inside of the PML pan. |
Before picture:Stock pan on Darryl's truck |
After picture:PML extra-capacity pan installed |
Darryl's 2005 Titan SE 4WD crew cab - looking good and running cool |
2006 Armada in the garage for transmission service and new PML RE5R05A pan |
PML pan fits great - putting in the drain plug now |
Ready to go |
|
The standard Titan transmission temperature gauge works independent of the transmission pan. The boss in provided in this pan can be machined for use with aftermarket sensors and gages. Read on the Titan Talk forum about lower transmission fluid temperatures after installing a PML pan in the Titan performance modications thread. PML Transmission Pan Features
Find out why you should buy a PML transmission pan. Gasket and filter not included (use stock parts). If you would like PML to machine your pan for a temperature sensor, there is an additional charge of $40. Please place your order over the phone if you would like machining. For a larger picture, please click on one of the above images. A separate window or tab will open showing a bigger picture. (The larger pictures take a minute to display.) |
||
|
|
PML, Inc. 201 W. Beach Avenue Inglewood, CA 90302 (310) 671-4345 www.YourCovers.com yourcovers@pmli.com |
|
|
Copyright 2000-2011, PML, Inc. |
|||